Remove and replace the existing HVAC unit. Install a new minimum 14.3 SEER2 rated energy efficient gas unit. Install new copper line-set, appropriate filter drier, thermostat, and registers. Caulk all ceiling drops to drywall before air register installation. Seal the return air cavity with drywall for energy efficiency. Insulate the duct where needed. Replace the plenum if required for proper fitment of the new unit. If duct board is to be used for transition to plenum, all joints must be foil-taped, and an acrylic latex or mastic sealant is to be applied over foil-taped joints. The contractor will be responsible for the proper sizing of the new unit. The contractor must provide the AHRI certificate for the equipment to be installed with the bid.

Remove and replace 1 entry door in the garage area. Install 1 pre-hung six panel insulated metals door. Install all trim required for proper fit and finish. Install new combination, keyed alike hardware, Kwikset or comparable. Caulk and seal inside and out. Paint to match new or existing finishes. Install 2 storms doors equal to a LARSON brand with new hardware including safety chains. Install new weather strips on the front entry entry door.

Install new vinyl soffit, (perforated as needed for proper ventilation), and siding on front porch, over the window on the porch, and garage area. Cover all exposed wood surfaces with PVC coated coil metal, leave nothing on the exterior of the home uncovered to be painted except the porch post that are made from steel pipe, paint all porch post all one color to be selected by the homeowner.

Repair the electric in the kitchen and dining room area that is not working, check the electric throughout the entire home and make any needed repairs, use any and all materials to restore the electric back to working order. Remove and replace the attic fan and cover with new fan and cover. Install foam socket sealers on all electrical outlets and switches throughout the entire home and replace any needed covers.

Caulk and seal all windows and doors, remove and replace the corner post on the garage area with a new post painted to match the existing post. Remove the caulk from around the windows on the exterior and foam seal the windows and then re-caulk them.

Install a dielectric gas fitting on the gas line where the gas line comes up out of the ground before it enters the home.

Install new painted seamless gutters with leaf guards on the front and back of the home with all needed down spouts, install concrete splash blocks for each down spout. (Approx. 110' gutter).

All work done must meet or exceed 2019 IRC. All applicable licenses apply. It is highly recommended contractor view job before biding. Contractor is responsible for all line locates and permits required Contractor will be responsible for cleanup and removal of all waste and repair yard back to mowing condition. Homeowner/Property Manager will select any/all colors used for the job. Contractor is responsible for all measurements, and count of materials needed.